The scraper is suitable for underground mine operation

1. The maintenance worker is responsible for removing the bucket and tail cover before the scraper goes down the well.

2. Safety officers, repairmen, electricians and other auxiliary workers are responsible for the safety of the forklift into the tank and fixing work, and can be checked by the mine before going down the well.

3. The scraper is lowered to the -110m level and fixed on the pallet truck with 5t chain and steel wire rope, and the mining mechanical department and Safety Department assist in inspection and acceptance. The accessories removed by the forklift truck are loaded into the 1.2m3 fixed tank truck and transported to the blind incline through the transport lane of the upper panel, from which the blind incline is lowered to the -170m level.

4. When the scraper is transported to the -110m horizontal blind inclined shaft wellhead, carefully check the binding and fixing situation. In order to prevent sliding when the inclined shaft is lowered, there are many unsafe factors, it can be considered to remove the scraper rubber wheel for easy fixing.

5. When the blind inclined shaft is lowered, the hoisting speed shall not exceed 0.5m/S; Due to the deviation of the width of the board car over -170m, double care should be taken when throwing the lane, and measures should be taken to prevent the heavy car from turning over.