What are the requirements of the underground scraper before working underground

Underground loader manufacturers explain what are the requirements of the scraper before underground work? Often check the tightness of the shaft end fastening screws and tire screws to prevent accidents. During inspection, repair and refueling, the scraper must be stopped, the power must be cut off, and the bucket must be grounded. During inspection, repair and refueling, all parts of the machine must be completely at rest and in a stable state. Due to the limitations of underground working conditions, it is strictly prohibited to stand before and after the scraper in the work site, stop and stack other machine items on the transportation road.

Before working, the driver must carefully check the various parts of the scraper and the working environment, and then operate according to the operating procedures. When lifting the boom of the scraper, it is strictly forbidden to stand under the arm, and the maintenance must also be carried out by reliable sleeper support. Disassemble and repair after the replacement wheel is deflated.

When the brake of the underground scraper fails, it should be stopped immediately for maintenance to keep the brake in good condition. Non-drivers are not allowed to arbitrarily turn the control handle and operate the machine. After stopping, you must cut off the power supply and check whether the parking brake is reliable. The bucket must land. All four wheels must be stoned to stop on a slope. The above is the relevant knowledge of underground loaders, welcome to pay more attention to our website!